Just bought something shiny on eBay...

[cpd]

http://cgi.ebay.com.au/ws/eBayISAPI.dll ... 4617142504

Ooh, it's so pretty. I think I'll be needing to lengthen a tube a little bit to get my air filter completely over the hole above my wheel arch, but that's no big deal. have to drill a hole in it for my air intake sensor though; it's hanging down in the middle of my tube at the moment.

Should I perform an ECU reset after this? (I assume I just do the idle procedure then drive it like normal.)

[ubuyau]

http://cgi.ebay.com.au/ws/eBayISAPI.dll ... 4617142504

Ooh, it's so pretty. I think I'll be needing to lengthen a tube a little bit to get my air filter completely over the hole above my wheel arch, but that's no big deal. have to drill a hole in it for my air intake sensor though; it's hanging down in the middle of my tube at the moment.

Should I perform an ECU reset after this? (I assume I just do the idle procedure then drive it like normal.)

Congrats man. That looks like a good piece

Good you get the two silicone joiners too - you can use the extra 3inch straight one to connect another length of tube then...

You can pilot drill the silicone joiner (then increase the size of the drill bit) and push in your sensor, then seal it up with some AllClear rather than drilling the pipe.

I'd do the ecu reset Just to make sure everything gets re-learnt... ive been meaning to do one for a while...

--Tim

[cpd]

So relearn the entire thing, like doing 60 for so long, etc etc? I think I saw that somewhere?

Gawd, I'd have to go to Wakefield Park to do that.

[ubuyau]

So relearn the entire thing, like doing 60 for so long, etc etc? I think I saw that somewhere?

Gawd, I'd have to go to Wakefield Park to do that.

Idle re-learn - http://www.daewootech.com/forum/viewtopic.php?t=2609
Thats what i do - works good.


You should want to go to Wakefield anyway

--Tim