let rods

debo890 · Post by **debo890** » Wed Aug 10, 2005 7:35 pm

anyone intrested in a set of let rods for about $400

GsiTurbo · Post by **GsiTurbo** » Fri Aug 12, 2005 6:19 pm

For those who dont know, these are C20LET rods (factory turbocharged 2.0 DOHC), capable of roughly 300 whp...and are straight swap in any 2.0 DOHC engine.

Post by **PrecisionBoost** » Sat Aug 13, 2005 5:42 am

I'll give you $50 and a boot to the head

For some reason I never got any serious offers for a "boot to the head" when I posted it in the classifieds a few months back.

I might be interested if I didn't allready have a set.

Why are you selling them..... aren't you using them in your turbo engine??

debo890 · Post by **debo890** » Tue Aug 16, 2005 7:00 am

i am also consedering forged sets. if i sell this, i save up and get forged ones. if i dont, i go ahead with project.

Post by **PrecisionBoost** » Tue Aug 16, 2005 10:42 pm

Ya.... I was looking for a set of forged rods as well.

ArrowPrecision out of the UK will sell a really nice set for around $1000 USD but I think you can find them cheaper at a USA based company such as Pauter and Crower.

I can't remember but I think Pauter quoted me $680 USD for a custom set.

I figure the C20LET rods should be good enough.... I don't think I will exceed 300whp.... but then again who knows

Post by **Efratech** » Wed Aug 17, 2005 12:45 am

the exchange rate sucks eh?

daewooluvr · Post by **daewooluvr** » Thu Aug 18, 2005 4:02 pm

Erfinder@PrecisionBoost wrote: I can't remember but I think Pauter quoted me $680 USD for a custom set.

Yeah that's about right what they quoted me as well...