The daewoo

buddha102 · Post by **buddha102** » Sat Jul 26, 2008 9:10 pm

hehe nice, btw does the cold air intake gives you higher RPM at idle? cause i remember my bro had a mustang and he put the cold air intake and it was running like crazy at idle

(he had no check engine light come on)

sheepdizildawg · Post by **sheepdizildawg** » Sat Jul 26, 2008 9:46 pm

mine ran a lot smoother and it gives it a nice sound too. I have a it set up as a short ram, because sound is louder, but I have the tube feeding it cold air, so I have the benefit of cold air.

ok guys, have a question, My engine has been making a ticking noise, and if i spray WD-40 into where the timing belt is, it stops for a while, that and my engine is pretty noisy, look at these videos that I uploaded, anyone know what it might be?

http://www.youtube.com/v/BLuRvpbCIRc&hl=en&fs=1

and

http://www.youtube.com/v/b8ILvMOwo9s&hl=en&fs=1

any ideas?

sheepdizildawg · Post by **sheepdizildawg** » Sat Jul 26, 2008 9:49 pm

and no not the ticking from the injectors. you can hear it a little at the second one. its not as bad right now as some times, it will be fine when i turn the car off, then when i start it back up like 5 minutes later the noise is there

Big Jeff · Post by **Big Jeff** » Sat Jul 26, 2008 10:01 pm

not trying to be mean or anything
but went was the last time it had it timing belt, tensioner and water pump change?

sheepdizildawg · Post by **sheepdizildawg** » Sat Jul 26, 2008 10:03 pm

to tell you the truth, I dont know, had the car since last February and I havnt done it, I was thinking about doing it soon, think it might be that? and how hard is it to do?

you can hear it more at the end of this video I made a long while back

http://www.youtube.com/v/b8ILvMOwo9s&hl=en&fs=1

thats before i put much of anything into my car. its near the end that you can hear it

sheepdizildawg · Post by **sheepdizildawg** » Sat Jul 26, 2008 10:07 pm

http://cgi.ebay.com/ebaymotors/99-02-DA ... 0273858675

that a decent price on all of it? or is there somewhere else I can get it?

sheepdizildawg · Post by **sheepdizildawg** » Sat Jul 26, 2008 10:08 pm

http://cgi.ebay.com/ebaymotors/DAEWOO-L ... 0274058381

cheaper one

buddha102 · Post by **buddha102** » Sat Jul 26, 2008 10:41 pm

try anything than ebay like:

http://www.carpartswholesale.com

http://www.overnightautoparts.com

Big Jeff · Post by **Big Jeff** » Sun Jul 27, 2008 12:34 am

Don't go to ebay!

it could the berings in the water pump,Tensioners?

i've got a ticking/rattle noise coming from engine bay and the garage said it was the water pump on its last leg

sheepdizildawg · Post by **sheepdizildawg** » Sun Jul 27, 2008 1:11 am

well being only 17 working for minimum wage and paying bills, I have never had a problem with ebay, buy everything from there, those sites you gave me, everything would be over $200. i dont have that kind of money right now. any pther car have the same stuff on it?

buddha102 · Post by **buddha102** » Sun Jul 27, 2008 2:53 am

sheepdizildawg wrote:well being only 17 working for minimum wage and paying bills, I have never had a problem with ebay, buy everything from there, those sites you gave me, everything would be over $200. i dont have that kind of money right now. any pther car have the same stuff on it?

well, its the 2nd site if u cant get it off ebay

sheepdizildawg · Post by **sheepdizildawg** » Sun Jul 27, 2008 6:13 am

other*

like any other car use the same belt and pump

daewoomofo · Post by **daewoomofo** » Sun Jul 27, 2008 4:41 pm

dont just get the chepaest belt kit you can find, if you can find/afford it get a gates belt. a kit for an eveo should work too. partsdinosour on ebay had nice kits, thats where i got mine, not too hard to do either. just dont wait too long cause its not a matter of if it will snap, its a matter of when.

buddha102 · Post by **buddha102** » Sun Jul 27, 2008 5:52 pm

daewoomofo wrote:dont just get the chepaest belt kit you can find, if you can find/afford it get a gates belt. a kit for an eveo should work too. partsdinosour on ebay had nice kits, thats where i got mine, not too hard to do either. just dont wait too long cause its not a matter of if it will snap, its a matter of when.

i might have to check my for any cracks or wear outs, u might never know....

MMamdouh · Post by **MMamdouh** » Mon Jul 28, 2008 7:45 am

hey sheepdizildawg... did you ask your friend about the type of bimmer that donated the springs you are using?

MMamdouh