Installing Head in a Leganza In Need of Torque Values!!!!

rmarkham · Post by **rmarkham** » Thu Jun 05, 2008 5:17 am

I have a clicker type torque wrench and I have gotten instructions on how to install the head bolts correctly but the instructions I have require an angular torque wrench. I would really appreciate any help on how to install the head correctly as I do not wish to do this again. The car is a 2000 Leganza with 80,000? miles on a 2.2 Dual Overhead Cam.
Thank you in advance for any information you may be able to provide.

Daniel · Post by **Daniel** » Thu Jun 05, 2008 8:14 am

Follow service manual.
Get new head bolts & gasket.
Clean the threads of engine block.
You can buy a angular torque adapter http://www.chain-auto-tools.com/engine_ ... MM252l.htm .
I recommand you to read http://www.daewootech.com/forum/viewtopic.php?t=8328 .
A Leganza partial service manual can be found here: http://www.daewootech.com/forum/viewtopic.php?t=5085 .

Daniel

Post by **PrecisionBoost** » Fri Jun 06, 2008 12:13 am

Go through the TECH SPECS area of this forum for technical info

http://www.daewootech.com/forum/viewtopic.php?t=9835

This is for the Nubira 2.0L but I'm pretty sure they are identical for the 2.2L Leganza (since they are the same cylinder head... just the block is a tiny bit different.... deck height is up 1cm )

rmarkham · Post by **rmarkham** » Fri Jun 06, 2008 10:35 am

Thank you for all your help. We found the proper tool needed for the job. Now we get to put it all back together.
Thank you Very much!!

The original daewootech forum

Installing Head in a Leganza In Need of Torque Values!!!!

Installing Head in a Leganza In Need of Torque Values!!!!

Thank you!!!