This is a kind of how to/progress type post. Didnt know where best to put it so plonked it here!
OK heres the progress from start to... well, where i am now
Before i mould anything i did a test. I actually cut the buttons off before i tested it so godd job it worked!!
Then sized it all up with my dash piece and cut it untill it fit well
Then i started to glue the bezel to the dash piece. Normal super glue used for most of this.
Pic of front at this stage
Added 1st lot of filler
I Then realised that i had no raised edge at the top to filler it up nicely so i popped down to BnQ n paid bloody 4 quid for a 2 meter bit of wood which i only needed 15 cm of.
Fillered up and test run
I then just did alot of sanding and more sanding and filling ans sanding untill i got to this...... Not fully done but primed. Just needs a few imperfections taken out and its done! Not bad for a 1st attempt
that looks good. a former member named Norbie had a carputer, i was in the planning stages fo doing it too, but then the tranny in my old woo crapped on me. one day ill start working on gerring one in my new woo.
Help keep Daewootech spam free, reply "Killspam" (no spaces) to spam posts
yeah i know norbie. I bought the touchscreen off of him lol. I have gone 1 step further though with fabbing it into the dash but he has helped me quite alot. Cheers comment
Ive sey up something of my own, used a laptop with no screen, mounted under the passenger seat. added in a 7 inch ELO touchscreen frim an ond cop car. with the addition of a wireless keyboard it works well and fedora core 7 easliy interfaces with the obd2 system of the car for lots op fretty readouts.