:lol: I finally figure out what's wrong with my car

greatiliad · Post by **greatiliad** » Wed Oct 04, 2006 1:40 am

First of all, I have to say sorry, My Woo
This time, it is my fault.
Actually, a month ago, the check engine light flashed for a while, the reason is the crank shaft pulley is not installed properly, which is my fault.
and the reasult is the tooth on crank pulley puller was damaged.
finally, it will cause the pulley slip.

the ECU will lost the the crankshaft position. and casue wrong igination time, which cause the car can not accelerate.

My WOO, I will fix you in the coming week

greatiliad · Post by **greatiliad** » Wed Oct 04, 2006 1:43 am

today, I talked with a mechanic, and he gave me the idea that the timing may not right
actually, my timing is perfect, but I began to move my focuse on the timing system, finally, find out what's wrong.

I strip everything on the pulley, and tighten it, my car just runs perfectly.

Daniel · Post by **Daniel** » Mon Oct 09, 2006 4:24 pm

Glad to know you have sorted the problem.
Goooooooood car

.

Daniel

lanowoo · Post by **lanowoo** » Tue Oct 10, 2006 8:23 pm

i am glad that you know whats wrong, see woos aren't bad :P

JohnnyC · Post by **JohnnyC** » Wed Oct 11, 2006 6:23 pm

Hmmm I wonder if my problem could have something to do with the Crank Shaft Pully/sensor too... I should clean that up when work on it next.

MMamdouh · Post by **MMamdouh** » Thu Oct 12, 2006 11:03 am

i'd have a look at it too... i recently borrowed a functional coil pack but that didn't help.

MMamdouh