Car Audio, Controllers, Wiring, Seats, Carpet, Interior painting, and more...
Moderators: daewoomofo , Moderators Group
MickeyX
Posts: 33 Joined: Mon Apr 04, 2005 10:04 pm
Location: Los Angeles, CA
Post
by MickeyX » Mon May 22, 2006 7:12 am
Hey guys, one bright day my signals and emergency lights all went out. Then once i went over a bump and it started working for a bit but then went out again. Any suggestions?
Gorbi
MMamdouh
Moderator
Posts: 7299 Joined: Wed Feb 18, 2004 8:33 am
Location: Cairo, Egypt
Contact:
Post
by MMamdouh » Mon May 22, 2006 7:25 am
as long as it is related to physical movement then it is loose wiring or bad contact, check all wires and relay sockets.
MMamdouh
JohnnyC
Expert
Posts: 1433 Joined: Tue Jan 31, 2006 4:48 am
Location: Kalamazoo, Michigan
Contact:
Post
by JohnnyC » Mon May 22, 2006 8:57 am
When my right front blinker stopped working properly, I found that the ground wire had been cut apart under the headlight.
Fixed it though
delphis
Expert
Posts: 724 Joined: Tue Mar 01, 2005 7:05 pm
Location: San Fransisco Bay Area
Contact:
Post
by delphis » Tue May 23, 2006 2:20 am
check the back of your hazards switch in the middle of the console. if it isn't plugged in or got giggles loose than it is probably the scenario. because if that switch isn't plugged in then nothing will work.
1989 240sx fastback with SR20DE
lanowoo
Expert
Posts: 783 Joined: Tue Apr 11, 2006 7:10 pm
Location: U.S.A~ somewhere.
Post
by lanowoo » Tue May 23, 2006 2:33 am
make sure the relay and fuse are in their respective places and make sure they are tight.
WOOOOO HOOOOO for a DAEWOO!!
-SRI -RE:APC STAINLESS STEEL PERFORMANCE FILTER
-VALVE COVER VENT FILTER
-CUSTOM ROD CRYSTAL DRIVING LIGHTS
-1200W AMP WITH 12" SUB -KICKS WOO BUTT!!!!!