What Can I Do with this and what can it do for me?

N/A tech, Cold Air Intakes, Spark Plugs/wires, Cat backs, Exhaust...etc

Moderators: daewoomofo, Moderators Group

User avatar
lanowoo
Expert
Posts: 783
Joined: Tue Apr 11, 2006 7:10 pm
Location: U.S.A~ somewhere.

Post by lanowoo »

i havent personally looked into too of a depth into the cam leaking put when i drive my car to say a mall and leave it and come back in about an hour or two, there will be a United states dollar size (3-1/2 x 4-3/4) drops on to the pavement. It fairly bad, but i have no real shelter to take and put it on jackstands and start jumping into it. I check what i can.
Here is a picture of where it is comming out of the front, sorry for the bad representation, i have no camera or scanner.
Image
WOOOOO HOOOOO for a DAEWOO!!
-SRI -RE:APC STAINLESS STEEL PERFORMANCE FILTER
-VALVE COVER VENT FILTER
-CUSTOM ROD CRYSTAL DRIVING LIGHTS
-1200W AMP WITH 12" SUB -KICKS WOO BUTT!!!!!
User avatar
lanos2001
Expert
Posts: 4245
Joined: Thu Sep 30, 2004 9:35 pm
Location: lawton oklahoma

Post by lanos2001 »

so its leaking from the top by the oil cap?!?!?


nick
Image

save a tree, eat a beaver.
MMamdouh
Moderator
Posts: 7299
Joined: Wed Feb 18, 2004 8:33 am
Location: Cairo, Egypt
Contact:

Post by MMamdouh »

well based on your drawing that could be the cam cover or cam shaft seal.

basicly for hunting down an oil leak we clean up the area where the oil is covering the surface till it is crystal clean then drive the car for a while and recheck the cleaned area... this way you can find out the leaking source before the oil stains smeres all the engine block.

if you can do it yourself try to remove the timing belt cover and take a look at the cam shaft seals area... if it is covered with oil as well then most probably you got cam shaft seals issue.

i strongly recommend a good engine cleanup followed by a throughout inspection for that leak.

MMamdouh
Driving is the utmost fun you can have with your pants on!
Check out my ride: http://www.cardomain.com/ride/567267
Image
User avatar
lanowoo
Expert
Posts: 783
Joined: Tue Apr 11, 2006 7:10 pm
Location: U.S.A~ somewhere.

Post by lanowoo »

I finally taken the cover off and to my suprise it is not leaking aroung the cam seals, there is a little bit of a coat of oil on the camshaft gears, but it isn't nearly the amount that is ending on the ground or the front of the engine. My only guess is the camshaft top is warped... or the cover.. i don't have very much $ right now. But i wonder how much getting the top shaved would be, probably $250 (USD) or a new cam cover. Hey would you know how much they would cost, i will give you the cam cover part #
Part #: 96351548. i cannot find a price since the dealership i go to doesn't open up untill sunday (wierd hours.)
WOOOOO HOOOOO for a DAEWOO!!
-SRI -RE:APC STAINLESS STEEL PERFORMANCE FILTER
-VALVE COVER VENT FILTER
-CUSTOM ROD CRYSTAL DRIVING LIGHTS
-1200W AMP WITH 12" SUB -KICKS WOO BUTT!!!!!
daewoomofo
Moderator
Posts: 4795
Joined: Fri Nov 18, 2005 1:41 am
Location: 313

Post by daewoomofo »

there is one on ebay for pretty cheap, http://cgi.ebay.com/ebaymotors/Valve-Co ... enameZWDVW
merry x-mas
Image

Help keep Daewootech spam free, reply "Killspam" (no spaces) to spam posts

yeah i cant type, so what big freaking deal!
User avatar
lanowoo
Expert
Posts: 783
Joined: Tue Apr 11, 2006 7:10 pm
Location: U.S.A~ somewhere.

Post by lanowoo »

thanks, that will help me but the only thing is that my pay-pal is suspended for some odd reasons.
WOOOOO HOOOOO for a DAEWOO!!
-SRI -RE:APC STAINLESS STEEL PERFORMANCE FILTER
-VALVE COVER VENT FILTER
-CUSTOM ROD CRYSTAL DRIVING LIGHTS
-1200W AMP WITH 12" SUB -KICKS WOO BUTT!!!!!
Locked