Need convertor to hook up aftermarket ignition coils Now!

Brian5475E · Post by **Brian5475E** » Wed Dec 14, 2005 1:43 am

I forgot who was making them. If your not gonna make them , please can you refer me somewhere else so I can get this finished on my Aveo. Thanks

DomWoo · Post by **DomWoo** » Wed Dec 14, 2005 2:23 am

360dynamics might have some left or he can make you one, but you will need an ignition box also i believe

Post by **PrecisionBoost** » Wed Dec 14, 2005 2:26 am

That would be me.... I will go upstairs to the electronics lab and take a look at where I'm at.......just a minute.... yup.... I have two finished and two more circuit boards that just need assembly.

So..... who all needs them..... better speak up now.... don't forget I'm lazy.... so it might take another six months before I get around to making another set.

I don't remember how much they are..... they are usually sold through 360 Dynamics.... since he has paypal and his business is set up.

Where as I don't have a business license or insurance.... I've been waaaaayyy to busy to do anything with Precision Boost Systems.

Post by **PrecisionBoost** » Wed Dec 14, 2005 2:34 am

Good point..... I hope you realize that this is just an interface driver.

If you try to hook up an aftermarket system like the MSD DIS-2 it won't run due to the fact that the ECU is sending out the wrong signal.

So...... that's where my driver circuit comes in..... it takes the ECU signal, modifies it and amplifies it so that the MSD ignition system can get a nice clean signal.

You need...... aftermarket coils, ignition system and my driver to make it work.

I personally have the Programmable DIS-2 system and a set of Neon coil packs.

I haven't installed mine yet..... but WooHoo has had his DIS-2 running for well over a year now.

Post by **PrecisionBoost** » Wed Dec 14, 2005 2:39 am

you know..... I wonder..... I used some pretty massive driver transistors.... I'm thinking they might run a coil pack without an ignition system.

Hmmmmmm ..... I will have to think about that..... I'd have to try it out and see..... I'm not sure how much current the primary coil produces when the circuit hammers it to ground.

Tom likes high voltage..... I will get him to hold the spark plug lead when I trigger the coil :twisted:

kinkyllama · Post by **kinkyllama** » Wed Dec 14, 2005 3:06 am

I need em!

Brian5475E · Post by **Brian5475E** » Wed Dec 14, 2005 4:00 am

Put me on the list

debo890 · Post by **debo890** » Wed Dec 14, 2005 2:24 pm

i'll take one.