D-series header on Lanos

CustomLanos · Post by **CustomLanos** » Wed Nov 30, 2005 4:28 am

Has anyone tried using a d-series honda header on a 1.6 lanos? i know woohoo used the turbo mani but has anyone tried using just a regular header? and does anyone know if i could use all the 02 sensors from the lanos on the honda header?
http://us.st7.yimg.com/store1.yimg.com/ ... 0_95352808

Audacity Racing · Post by **Audacity Racing** » Wed Nov 30, 2005 4:29 am

you could use the shorty section... but you'd have to make your own down-pipe... otherwise you'll hit the oil pan

CustomLanos · Post by **CustomLanos** » Wed Nov 30, 2005 4:30 am

thats what i was thinking....i think im going to try it...

Brian5475E · Post by **Brian5475E** » Wed Nov 30, 2005 12:28 pm

I tryed it. The flange is too different. The ports don't line up. but the down pipe lines up perfect on the Aveo

Post by **Efratech** » Wed Nov 30, 2005 2:42 pm

Woohoo has a d16 turbo manifold on his A16...

im with Audacityracing on this one.

Audacity Racing · Post by **Audacity Racing** » Wed Nov 30, 2005 3:34 pm

doesn't the aveo hard have squareish exhaust ports?

CustomLanos · Post by **CustomLanos** » Wed Nov 30, 2005 4:08 pm

if the turbo manifold fits on woohoo's lanos why wouldnt the n/a header fit on the lanos too?

Audacity Racing · Post by **Audacity Racing** » Wed Nov 30, 2005 4:13 pm

it'll fit... you'll just have to port match it

CustomLanos · Post by **CustomLanos** » Wed Nov 30, 2005 4:26 pm

what do you mean port match? do you mean i have to drill the holes for the bolts bigger.

Audacity Racing · Post by **Audacity Racing** » Wed Nov 30, 2005 4:28 pm

no no, place the gasket on the head... spray a thin layer of paint over it... this shows the excess material that's in the way... then you do the same to the header... then take a dremel or grinder and remove the painted sections.

look in the ARTICLES OF INTEREST post in general for a thing on it in detail