how to hook up SAFC II to the Aveo. Need Aveo wire diagram!!

Brian5475E · Post by **Brian5475E** » Thu Aug 18, 2005 11:02 pm

I know someone on here hooked up one to a forenza or optra. I do believe the aveo uses the same Delphi EMS (MR-140ECM). what is the wire hookup?

Post by **PrecisionBoost** » Fri Aug 19, 2005 2:37 am

Ya.... that was me.

It was really easy.... you can find all the ECU wires you need about 6 inches down from the two ECU Connectors.

I think I have an aveo pinout in my GM Techline manual..... I will check it out.... PM me with your email address and I will send it your way.

Brian5475E · Post by **Brian5475E** » Fri Aug 19, 2005 2:43 am

I found the schematic online. I'm buying a SAFC II tomorrow for $90 I just hope I can tune this thin alittle better. after I get the U/D pulley on I'm gonna get it dynoyed and tuned with the SAFC

Post by **PrecisionBoost** » Fri Aug 19, 2005 3:49 pm

That's a great price.

You will find the A/F ratio pretty decent allready...... my reason for picking it up was for the Turbo engine swap.

I fooled with it for a half hour on the dyno one night and I think the most I could get with tuning the N/A engine was 2hp.

Who knows.... perhaps the Aveo will be different.... I guess we will see.

If it weren't for the fact that you were planning on a turbo down the road I would tell you not to bother getting the SAFC II ( then again... for $90... it's a cool toy )