![Image](http://www.postimage.org/Pq1nCRkJ.jpg)
![Image](http://www.postimage.org/aVO6LS9.jpg)
![Image](http://www.postimage.org/Pq1nDmLA.jpg)
![Image](http://www.postimage.org/aVO72k9.jpg)
![Image](http://www.postimage.org/aVO7wfS.jpg)
![Image](http://www.postimage.org/aVO7oMr.jpg)
![Image](http://www.postimage.org/aVO7NIS.jpg)
![Image](http://www.postimage.org/Pq1nDJcS.jpg)
pulled the pistons today... the bearings look ok but there was a ton of play in the rods on the crank
![Confused :?](./images/smilies/confused.gif)
Garrett
Moderators: daewoomofo, Moderators Group
You tapped both? My cooler Z20LET therm has the same piece tapped on the left.gse_turbo wrote:here is where the water supply for the turbo should be tapped, there is more pressure here than the back side o fthe head where it was before.
I tapped two 1/4" pipe thread holes, both spots are just as good but I like the one by the bolt hole becase there is more material fo rthe threads.