Lanos 16v turbo exhaust manifold

[benzino]

cast iron is very different to cast steel...

[mohmedhat]

here is an example of the casted discharge elbow i like to have:

[gse_turbo]

do you already have the turbo? is one of those yours?

[mohmedhat]

no above turbo's are just to show the casted downpipe not more mine is TD04l out of a Subaru wrx like Jorge's one.

[mohmedhat]

by the way who don't like ubuyau setup it's the cleanest and the most OEM lockable setup i love it and hope mine looks the same when i finish it






keep everything in place, fans, oil filter, air conditioner, etc. more than perfect!

[gse_turbo]

I like it, it's very clean.

keep in mind though, the turbo will sit lower than the highest part of the oil pan. if you don't have a reservoir and a small scavenge pump on the oil return you will have issues with wearing out the turbo quickly.

something like this one...

turbo resevouir.jpg

(28.36 KiB) Downloaded 598 times

[benzino]

i don't know if ubuyau had any problems with that

[mohmedhat]

every time i said huh finally finished my list then suddenly i find their is still a lot missed !!
can you explain more for me please? and give me some photos for the return line pump and reservoir?

[mohmedhat]

Garrett, please ship the e-manage with it's stuff

seams the flange will take very long time and i will not be able to wait for it, ship the e-manage and then we can find out a what to do with the flange and we can ship it alone.

thank you in advance...

[mohmedhat]

is the aveo 1.6 header is better than my lanos one? stronger or shorter so it may hold the turbo above the oil pan?

[gse_turbo]

they are actually the exact same manifold

[mohmedhat]

thank you, you are always there!

[bigted83]

which honda header will work? i have a 2001 daewoo lanos with a 1.6 liter 4 cylinder and a automatic. im looking to sell it if possible but if not i will keep the car and drive it

[Rafy]

what is the serial nr of your MSD ignition coil

[pulsardet]

Hi guys's here is your answer on your question, I currently test fit a serie D honda N/A header and a turbo manifold to my lanos 1.6 DOHC engine. But you need to clic on the picture to see the whole thing, but except 2 hold dont match up you need to slot a bit the hole. Also I had a question on my own i my thread if someome with experience might answer, I can maybe to the projet and update during the week-end hope it help, I think aftermarker D serie honda would be better option than running stock manifold off the woo. The only thing I am note sure is the exhaust gasket form the woo that has a particular shape.

http://www.daewootech.com/forum/viewtop ... =2&t=15513