For me the oven thing was a bad idea... take parts out, put in oven, remove the silicone, etc. Too much work! I hope you guys choice this option. For me it looks SICK!

Steps:
1. Wash your front lights with windex or other window washing product.
2. Take this part off the headlight. There are 2 screws on the bottom and should come right off.

3. Then put painting tape over the middle part and of head light, and the turn signal part. Red shows that that part should be covered 100%. Blue shows that is the boundary between the middle and the outer part. You might or have to have tape sticking out of the boundary. I did have sticking out and i cut it. If you want tape the boundary line without using you knife, then go for it. (skip step 4 for the last 2 sentences if you want to do that method)

4. This part is hard one. Take a razor knife and cut the tape that is sticking out of the boundary (blue line). Than do turn signal one. Take your time!!! No need to hurry!!!
5. Fun part!


You might have to paint it 2x or more if you want. I did my 2x just in case.
6. Put back the under the headlight piece and your set!
Results:
Before-
http://www.daewootech.com/forum/album_p ... ic_id=1008
After-
