well i'm back...

gse_turbo · Post by **gse_turbo** » Tue Sep 11, 2007 5:01 pm

well i'm back after a long two week holiday (wedding/honeymoon).

i know that i had some projects on the hold but now those projects have my undivided attention.

off the top of my head.. the Forenza/Reno strut brace, urethane bushings and a disc conversion kit for Audacity comes to mind, is there anything that i'm forgetting.

garrett

whiteraven · Post by **whiteraven** » Tue Sep 11, 2007 5:13 pm

Disc conversion for Aveos?

gse_turbo · Post by **gse_turbo** » Tue Sep 11, 2007 5:24 pm

i'll see what i can do.

garrett

daewoomofo · Post by **daewoomofo** » Tue Sep 11, 2007 9:18 pm

i has been wondering where you were. glad to have you back, hope the wedding and honeymoon went well.

gse_turbo · Post by **gse_turbo** » Tue Sep 11, 2007 9:57 pm

thank you everything went as good as possible.

garrett

Post by **PrecisionBoost** » Wed Sep 12, 2007 3:55 am

congrats on getting married.....

My advise.... ease into the projects slowly and make sure to spend a good amount of time with the new wife to show her she's the #1 priority.

People say that marrige won't change anything but there is allways something different.... it may take a couple of months before you notice the different requirements for attension.... and it's not necissarily an increase in attension.... sometimes it's just a matter of showing that you care more than you would when you were not married.

Good luck....Chris

gse_turbo · Post by **gse_turbo** » Wed Sep 12, 2007 5:41 pm

thank you for the advice!

garrett

exist3nce · Post by **exist3nce** » Mon Sep 17, 2007 2:27 pm

Congrats!

Are you talking about making urethane bushings for the endlinks? I could use some of those

Any chance on making urethane motor mounts?