How To: Remove Leganza Parcel Shelf

Car Audio, Controllers, Wiring, Seats, Carpet, Interior painting, and more...

Moderators: daewoomofo, Moderators Group

Locked
vjx987
Junior
Posts: 109
Joined: Sun Sep 25, 2005 2:07 pm
Location: Sydney

How To: Remove Leganza Parcel Shelf

Post by vjx987 »

To remove the Leganza Parcel shelf to install new 6x9 or sound deaden you need to do the following.

In the picture i have highlighted the areas which need attention, different colours to co-ordinate whats what and in which order.

Firstly you must Take out the back seat by reaching under the seat and simply lifting up, a clip will come out. There is one on either side. Once this is done, fold down the back seats.

Secondly HIGHLIGHTED BLUE are the side cushins. At the bottom of these cushins there is a bolt into the car, using a socket wrench or similar, undo these bolts and lift the pads directly upwards to remove them.

Thirdly HIGHLIGHTED YELLOW are three(3) plugs along the trim of the tray. Using a flat head screwdriver, get under these plugs and remove them.

Next HIGHLIGHTED GREEN lift the cap to the baby restraint and use the socket wrench to remove the bolt.

Next HIGHLIGHTED RED is the brake light. This is held on from under neath with 2 screws. Get in the boot and undo these screws. Once undone, lift the lamp and unattach the wire that comes up with the light.

Once all these steps are completed, simply pull the tray out from the car. Simply reverse the steps to replace. It is highly recommended that once out, you attach some extra foam to the tray for sound deadening as the stock foam deteriorates fast and will vibrate your shelf.

Image
'98 Daewoo Leganza SX
Locked