The I-Moni

asam · Post by **asam** » Sat May 14, 2005 1:41 am

This might work in our cars!!!

http://www.apexi-usa.com/product_electr ... &pageNum=1

lanos2001 · Post by **lanos2001** » Sat May 14, 2005 2:31 am

i saw that in super street mag once and was thinking about getting it but like everything else $$$$$ is what you need. i think it should work too.

nick

BosnianLanos · Post by **BosnianLanos** » Sat May 14, 2005 3:36 am

The i-Moni (i-Monitor) is a simple plug-and-play monitoring device which instantly installs using any factory ISO 14320 OBD II diagnostic port. The i-Moni offers real time data display of up to four different parameters including: Engine RPM, Water Temperature, Intake Air Temperature, and Vehicle Speed. Since the i-Moni utilizes information drawn from the stock sensors, there is no need for costly and time consuming aftermarket sensors. Simply plug in the i-Moni to any ISO 14320 OBD II port and instantly receive streaming data on your vehicles vital information.

RPM you can get from a tach, Temp we can get from the heat gauge, Speed from the speedometer, and intake air temp is kinda unnecessary, most likely a few degrees up from ambient temp outside. It is a neat little gadget, but IMO, it is a waste of money.

lanos2001 · Post by **lanos2001** » Sat May 14, 2005 3:41 am

the one i read about in super street was able to tell you the Horse power from the crank too. that was the only reason why i would've bought it. plus it would tell you your 0-60 and 0-100mph timing as well.

nick