tachometer install

taka · Post by **taka** » Mon Feb 21, 2005 11:38 pm

Hi, guys. I need some help for install the tachometer.
After I installed the tachometer, it looked working, but the tachometer only moved between 0 and 1000 RPM. Also, somehow, the high beam doesn't work... (normal lights work though), and airbag lump is always on. I don't think this is normal. So if you guys have any idea, please tell me. Thanks.

I put power suply for tachometer from the fuse box, and ECM/PCM for engine revolution. I hooked up the illiminaion light from the interpanel light control, which is located left of the handle. One more wire for underground. Do you think I did correctly??

AcingTeam · Post by **AcingTeam** » Tue Feb 22, 2005 12:31 am

Man, you probably messed it all up... the way I did it was, I connected all 3 wires (power, ground, lights) to my cd player wires, and connected the signal wire to the Green wire with Black stripe on the ECU behind the passenger seat.

taka · Post by **taka** » Thu Feb 24, 2005 4:25 pm

Hi, thanks for the advice.
Your way to install the tacho is pretty similar to mine except wires for the power supply. I should check those again.
Again, Thanks