How do you change shift knob?

EnderSR388 · Post by **EnderSR388** » Tue Jul 04, 2006 8:16 am

I'm new to the forum, this is my first post and I was wondering how you change the shift knob. I've seen photos of this being done, but don't know how to go about it. Does it just screw off? What about the release pull for reverse, what happens to that? Any info would be very much appreciated.

Thanks!

chris2511 · Post by **chris2511** » Tue Jul 04, 2006 8:28 am

You basically have to cut it off if you have the manual one, doesnt screw off.

EnderSR388 · Post by **EnderSR388** » Tue Jul 04, 2006 8:34 am

Wow, that sucks! Oh well. Thanks for the info though!

MMamdouh · Post by **MMamdouh** » Tue Jul 04, 2006 10:17 am

a detailed instruction is in the how to section.

MMamdouh

chris2511 · Post by **chris2511** » Wed Jul 05, 2006 8:25 am

EnderSR388 wrote:Wow, that sucks! Oh well. Thanks for the info though!

No probs man