Installing a strut bar

delphis · Post by **delphis** » Fri Dec 09, 2005 2:31 am

so when I go to install this do i need to support the top point or can I just un bolt it put it on and rebolt. I am worried that when I go to install this that when I loosen those bolts the spring will cause it to drop down and rendering it impossible for me to get it back up.

any help is always greatly appreciated!

Timmay

Audacity Racing · Post by **Audacity Racing** » Fri Dec 09, 2005 2:34 am

the car weighs enough to keep the body from popping off the top of the strut. you'll be fine if you just take the bolts out with the car on the ground

delphis · Post by **delphis** » Fri Dec 09, 2005 2:36 am

awesome, this bad boy is going on tomorrow, but I need to clean up my engine bay really badly, then I will take some pics.

MMamdouh · Post by **MMamdouh** » Fri Dec 09, 2005 1:03 pm

Audacityracing wrote:the car weighs enough to keep the body from popping off the top of the strut. you'll be fine if you just take the bolts out with the car on the ground

that is correct... it was practically proven by the asshole that did my first alignment job.

MMamdouh