Headlights Hazed Over.

Body Kits, Rims, Suspension, Wings, Lighting etc and exterior detailing.

Moderators: daewoomofo, Moderators Group

Locked
User avatar
BosnianLanos
Expert
Posts: 1661
Joined: Thu May 27, 2004 10:31 pm
Location: Clearwater, Florida
Contact:

Headlights Hazed Over.

Post by BosnianLanos »

My '99 Lanos headlights have oxidized, and while not completely, there is just enough yellow to piss me off. I really don't want my car to resemble a Dodge Neon :( with those lights that oxidize after a few months! My lights have even got dimmer due to it.

Is there a way to get rid of this? I've heard some guys use wetsanding, and then a plastic-polishing compound to get the shine back on their Neons, if so, what # of sandpaper should I use, and what compound is good? I've also seen the "Flitz" stuff that promises to take off "years of oxidation in a few seconds" amongst other things :lol: . Have you guys tried any of this on your Woos or other cars?

Any suggestions appreciated!
inertiaticesp
Posts: 8
Joined: Thu Aug 26, 2004 1:33 am

Post by inertiaticesp »

i had the same prob. i wet sanded with 1500 grit wet sand paper then buffed with 2 different polishing/buffing compound... i dont remember what brand though.....i think it was just for paint
TheGreatAndPowerfulOz
All Powerful
Posts: 2767
Joined: Thu May 01, 2003 10:37 pm
Location: Virginia, USA
Contact:

Post by TheGreatAndPowerfulOz »

For my dad's 1999 Kia Sephis, I just used the Turtle Wax brand Red polishing compound on a buffing pad on the end of an electric drill, and then used the White buffing compound to bring back the shine.

This is done with the buffing bad wet.

Also, remember to use a different buffing bad with the different compounds as the abrasive will remain in each pad.

I hadn't thought of using 1500 grit wet sand paper, but it sounds like it would be a choice.


Cliff
User avatar
GsiTurbo
Super Moderator
Posts: 1791
Joined: Thu Mar 13, 2003 10:56 pm
Location: Edmonton, Alberta, Canada
Contact:

Post by GsiTurbo »

any good point polishing compund (make sure you get the polishing compund, NOT other kind) will vey gently remove a thin layer of plastic and therefore oxidation. But DO TEST in a corner before you do entire lamps.
Image
__________________________
2002 Lanos 1.5 SOHC... stock!!!
User avatar
BosnianLanos
Expert
Posts: 1661
Joined: Thu May 27, 2004 10:31 pm
Location: Clearwater, Florida
Contact:

Post by BosnianLanos »

Will do! :D I'll use Turtle wax and a buffer.

Thanks.
Locked