Yet another clutch question for a lanos 1.6

Slammed · Post by **Slammed** » Sat Jun 17, 2006 12:43 pm

Ok I did some searching but found no usefull info
anyways I need a new clutch and dont want an oem one I would like a better response
I have found these can somebody recomend which one would be better

http://rep.racepages.com/parts/racepage ... c=true#top

http://www.autopartsauthority.com/parts ... my=1&cat=p

http://www.eclutchmaster.com/oemitem.asp?num=232

Post by **PrecisionBoost** » Sun Jun 18, 2006 10:53 pm

Personally..... I'd go with the Sachs... $125 is a really good deal.

These are all OEM style replacements.... if you want a better response you will have to spend more money.

Slammed · Post by **Slammed** » Sun Jun 18, 2006 11:15 pm

Ok what would you recomend??

chris@PrecisionBoost wrote:Personally..... I'd go with the Sachs... $125 is a really good deal.

These are all OEM style replacements.... if you want a better response you will have to spend more money.

Post by **PrecisionBoost** » Mon Jun 19, 2006 3:43 am

Well...... what is your budget.... and how much of a power handling capacity do you want?

I have two performance clutch/pressure plates on order..... same setup as Kinky's clutch.

I think we might have room for one more clutch in this order.... not sure of price... ask Kinkyllama.

It's a 6 pack clutch ( six pucks as opposed to the standard organic full surface type ) with a 1200lb pressure plate.

Slammed · Post by **Slammed** » Mon Jun 19, 2006 3:54 am

Well its a daily driver and I would just like it to hook up better and give me better performance

for example if I get on the highway and do 100MPH for 10 miles when I get off the exit my clutch pedel is all the way to the top and it takes awhile for the car to get up to speed (clutch is hot?) so I need a better performance one

MMamdouh · Post by **MMamdouh** » Mon Jun 19, 2006 9:20 am

what about Valeo??

MMamdouh

Slammed · Post by **Slammed** » Mon Jul 17, 2006 3:04 am

Is it good ??

GsiTurbo · Post by **GsiTurbo** » Mon Jul 17, 2006 11:50 pm

I had a valeo from 2.0 Lemans in the C20GET coversion. It held fine till 176hp/200lbs, but it start slipping at 196whp/248lbs torque. Not bad for clutch/pressure plate designed for 96hp/110lbs motor.