drilling rotors

daewoomofo · Post by **daewoomofo** » Sun Dec 18, 2005 10:52 am

i have a brand new set of oem style Brembo rotors sitting in the garage, i was wondering how hard i would be to drill them (like drilled and slotted) would it even help on the oem style or is it just too hard to do? any help is apreciated.

MMamdouh · Post by **MMamdouh** » Sun Dec 18, 2005 11:06 am

how hard? not hard at all but you will end up cracking the rotors and might even result in a horrifing accedent that clames your like.

i have asked the very same question and i got loads of replys suggesting not to do this.

http://www.daewootech.com/forum/viewtopic.php?t=3214

MMamdouh

daewoomofo · Post by **daewoomofo** » Sun Dec 18, 2005 11:18 am

ok.. thank you very much