Page 1 of 1
Whats the size of lanos front door speakers?
Posted: Thu May 04, 2006 12:28 pm
by MMamdouh
i know this might have been asked many times before but i got to be sure as i am considering a 5 1/4 inch KENWOOD speakers... is that the correct size for the front door speaker of a lanos??
MMamdouh
Posted: Thu May 04, 2006 1:19 pm
by TheGreatAndPowerfulOz
Stock door speakers are 4 inch and you have to make an adapter ring to fit the 5 1/4 inch.
It is MUCH easier to fit 5 1/4 inch than it is to fit 6 inch.
I used the factory plastic speaker holder and traced around it on 3/4inch thick MDF then drew in the circle of the size the 5 1/4 inch speakers needed and then cut it all out.
I have pics somewhere. Finding them is the difficult part.
Posted: Thu May 04, 2006 2:03 pm
by jorge
I have in my car 6.5 speaker I use Pioneer speakers because the deep of this speaker is 1 3/4. I use a .5 spacer. I buy it in a sound center. Is plastic.
Posted: Thu May 04, 2006 9:38 pm
by ubuyau
Yes depth is the problem...
I have had some 6inch Kenwood Component Speakers for a while now but they are thin speakers... (i think something like 57mm from a bad memory
)
3/4 or 1inch thick MDF spacer ring is your friend! Mine were still able to fit under the normal door trim!
--Tim
Posted: Thu May 04, 2006 11:07 pm
by woo
it seems like speakers are such a hassle in lanos's. I somewhat think i was lucky inheriting a leganza because it had 6.5' splits stock, so there were no dramas fitting my clarion splits
Posted: Thu May 04, 2006 11:58 pm
by TheGreatAndPowerfulOz
I fit 6 1/2 inch CDT component (split) speakers in my Lanos in the stock locations under the door panels. All I needed were MDF spacer rings.
The bottom of the door panel does not fit against the door any more; there is a 1/2 inch gap, but no one can see unless you look up from under the door.
Posted: Fri May 05, 2006 12:26 am
by daewoomofo
or you could mount the speakers through the door pannel, like i did, you cut the stoick meshing out and screw the speaker with its speaker cover that it came with right to the out side of the door pannel. really easy and no need to make mdf rings, it looks good too!
Posted: Wed Feb 27, 2008 9:45 pm
by barry
i imagine that also buys you an extra 1/2 of mounting depth too.
Re: Whats the size of lanos front door speakers?
Posted: Wed Feb 08, 2012 4:53 am
by gawa
How Do you take the Plastic Panel Off, There is no screw for the Door handle. Do you just pop it off with a flathead?
Re: Whats the size of lanos front door speakers?
Posted: Wed Feb 08, 2012 8:07 pm
by benzino
yes
Re: Whats the size of lanos front door speakers?
Posted: Thu Feb 09, 2012 1:39 am
by gawa
Awesome Thanks. I couldn't Figure that part out for a long time!