How to: Reset your ECU

[MMamdouh]

Resetting the ECU is done to wipe off all the feedback the ECU got about the engine, after doing that the ECU will start learning about the engine all over again so it can "feel" the new mods or service you just done.

1- unhook the -ve connector of the battery or the ECU's fues (check your manual for the correct fuse).
2- step on the brakes so that the brakes light drains any stored power in the car's electrical system.
3- put back the - ve connector of the battery.
4- turn on the ignition key on for 5 seconds then back off for 3 consecutive times
5-start the engine.
6- follow the learning procedure at this link:
http://www.daewootech.com/forum/viewtopic.php?t=2609

MMamdouh