Crankteeth?

kroz123 · Post by **kroz123** » Mon Oct 16, 2006 2:43 am

Hey Guys, anyone knows how many theet does the crank have (Optra,Lacetti,Forenza)?

I need to know cuz of the microtech.

I need to know 100%.

Thanx,

Arvin

Post by **PrecisionBoost** » Mon Oct 16, 2006 4:19 am

I'm pretty sure the T22SED (Leganza) is the same as the T20SED (nubira) and U20SED (Optra)

I have a spare U20SED but it's not disassembled at this point...... where as my T22SED is completely stripped down to just the block and crank.

So...on to your question.... it's a 6 degree trigger....meaning there are 60 teeth

However..... if you count them (which I did 2 minutes ago).... there are only 58 teeth because 2 are removed to indicate position ( I think it's TDC of cyl 1 )

I don't know what options you have with your microtech.... hopefully this helps you figure it out.

Chris

kroz123 · Post by **kroz123** » Mon Oct 16, 2006 9:15 pm

chris@PrecisionBoost wrote:I'm pretty sure the T22SED (Leganza) is the same as the T20SED (nubira) and U20SED (Optra)

I have a spare U20SED but it's not disassembled at this point...... where as my T22SED is completely stripped down to just the block and crank.

So...on to your question.... it's a 6 degree trigger....meaning there are 60 teeth

However..... if you count them (which I did 2 minutes ago).... there are only 58 teeth because 2 are removed to indicate position ( I think it's TDC of cyl 1 )

I don't know what options you have with your microtech.... hopefully this helps you figure it out.

Chris

Hey thanx Chris,

But is the U20SED the same as the T18SED in cranks?

Arvin