Need ECM schematic for forenza/ optra

Brian5475E · Post by **Brian5475E** » Fri Sep 23, 2005 1:59 am

I need the schematic for the forenza ecm so I can compare with the schmatic I have for the aveo, to see if the pins and wiring match up

Chip · Post by **Chip** » Fri Sep 23, 2005 5:31 pm

Brian5475E wrote:I need the schematic for the forenza ecm so I can compare with the schmatic I have for the aveo, to see if the pins and wiring match up

The Forenza ECM is identical to the Aveo ECM in terms of pin outs. In fact, you could run an Aveo on the Forenza ECM, although it would run rich and I wouldn't recommend it. You CANNOT run a Forenza on an Aveo ECM however due to the fact that it would lean out the mixture too much. Also, the wiring harnesses are different due to sensor locations.

-Chip

Brian5475E · Post by **Brian5475E** » Fri Sep 23, 2005 7:20 pm

so all I have to due is splice the connections to the inside of the car and fuel sending unit?

Chip · Post by **Chip** » Fri Sep 23, 2005 10:42 pm

Wait, what are you trying to do?

Post by **PrecisionBoost** » Sat Sep 24, 2005 1:08 am

Chip wrote:Wait, what are you trying to do?

I double that... what are you trying to do??

I do have Aveo and Kalos diagrams.... drop me a PM with your email address and I will see if I can extract the info your looking for.

I'm super super busy but I will try to do it in a reasonable timeframe.

Brian5475E · Post by **Brian5475E** » Sat Sep 24, 2005 1:57 am

I have the aveo wiring diagrams. it's just the wiring going from the. Nevermind duh, one of the harness goes to the car the other to the engine, just need the Forenza ECM plug and play. DUh I'm retarded!

The original daewootech forum

Need ECM schematic for forenza/ optra

Need ECM schematic for forenza/ optra

Re: Need ECM schematic for forenza/ optra