Web Camshafts

Brian5475E · Post by **Brian5475E** » Thu Aug 26, 2004 4:37 am

Found a place called Web camshafts in cali. They can hard weld cams( using stock ones) for 525 for set. Will increase Hp to 155 TQ to 135. They do alot for daewoo's in korea. Has anyone tried these?

daewooluvr · Post by **daewooluvr** » Thu Aug 26, 2004 12:51 pm

I've heard some good things about this company. What exactly does hard welding the OEM cams do?

Stefan · Post by **Stefan** » Thu Aug 26, 2004 8:46 pm

It's whats called in engineering 'hard facing'. Basically they deposit very hard weld metal onto the existing cam lobe, adding enough material to allow the cam to be reground for more lift/duration etc.

Stef

damian007vk · Post by **damian007vk** » Fri Aug 27, 2004 2:14 am

this is only good if you are planning to build HP all motor...in other words...naturally aspirated by raising compression....same goes for valve jobs, etc...these things work against forced induced cars......has anyone found out if they also can make the internals for turbo application???

Brian5475E · Post by **Brian5475E** » Fri Aug 27, 2004 8:12 pm

Umm!

that's why I put it in the N/A section and not forced induction. I talked to the guy there with a intake and free flowing exhaust w/o header the 1.6 can make 155 hp with these cams. They also make them for the 2.0l

Wolf-Spirit · Post by **Wolf-Spirit** » Sat Aug 28, 2004 10:53 am

ow the 1.6 @155hp ? not bad but what about RPM range? do you need to rev high to start moving?

The original daewootech forum

Web Camshafts

Web Camshafts

however