quick question about engine
Moderators: daewoomofo, Moderators Group
-
- Expert
- Posts: 342
- Joined: Wed May 07, 2008 4:42 am
- Location: Washington, USA
quick question about engine
the other day my engine was fine, and now since yesterday, it has lost power, when I step on the gas pedal it sounds like its trying to go up a hill, I am guessing either dead spark plug or a F*ed cylinder.. any thoughts?
-
- Moderator
- Posts: 4795
- Joined: Fri Nov 18, 2005 1:41 am
- Location: 313
- BosnianLanos
- Expert
- Posts: 1661
- Joined: Thu May 27, 2004 10:31 pm
- Location: Clearwater, Florida
- Contact:
-
- Expert
- Posts: 342
- Joined: Wed May 07, 2008 4:42 am
- Location: Washington, USA
-
- Expert
- Posts: 342
- Joined: Wed May 07, 2008 4:42 am
- Location: Washington, USA
- BosnianLanos
- Expert
- Posts: 1661
- Joined: Thu May 27, 2004 10:31 pm
- Location: Clearwater, Florida
- Contact:
-
- Expert
- Posts: 342
- Joined: Wed May 07, 2008 4:42 am
- Location: Washington, USA
-
- Moderator
- Posts: 4795
- Joined: Fri Nov 18, 2005 1:41 am
- Location: 313
-
- Expert
- Posts: 342
- Joined: Wed May 07, 2008 4:42 am
- Location: Washington, USA
-
- Moderator
- Posts: 4795
- Joined: Fri Nov 18, 2005 1:41 am
- Location: 313
-
- Expert
- Posts: 342
- Joined: Wed May 07, 2008 4:42 am
- Location: Washington, USA
-
- Expert
- Posts: 342
- Joined: Wed May 07, 2008 4:42 am
- Location: Washington, USA
just got back from autozone
this is what came up from scanning
P0420
The PCM has determined that the catalyst system efficiency for bank 1 is below threshold for the current engine operating conditions. (Bank 1 identifies the location of cylinder #1, while bank 2 identifies the cylinders on the opposite bank)
Definition
Catalyst efficiency low-bank 1
Explanation
The oxygen sensors monitor the catalytic converters ability to store oxygen
Probable Causes
1- Catalytic converter defective (Failure possibly due to #2, 3 or 4)
2- Engine misfire or running condition
3- Large vacuum leak
4- Engine oil leakage into exhaust-valve guide seals, piston rings
Ok well I dont have smoke so its not number 4, and my engine isnt miss firing as far as I can tell
and the other code they found was
P1627
module supply out of range
OEM Brand: General_Motors
definition
Analog to digital (A/D) performance
Explanation
The ECM has detected a fault in the A/D converter within the ECM
Probable cause
Failed ECM
hope my ECM isnt F*ed
any thoughts?
this is what came up from scanning
P0420
The PCM has determined that the catalyst system efficiency for bank 1 is below threshold for the current engine operating conditions. (Bank 1 identifies the location of cylinder #1, while bank 2 identifies the cylinders on the opposite bank)
Definition
Catalyst efficiency low-bank 1
Explanation
The oxygen sensors monitor the catalytic converters ability to store oxygen
Probable Causes
1- Catalytic converter defective (Failure possibly due to #2, 3 or 4)
2- Engine misfire or running condition
3- Large vacuum leak
4- Engine oil leakage into exhaust-valve guide seals, piston rings
Ok well I dont have smoke so its not number 4, and my engine isnt miss firing as far as I can tell
and the other code they found was
P1627
module supply out of range
OEM Brand: General_Motors
definition
Analog to digital (A/D) performance
Explanation
The ECM has detected a fault in the A/D converter within the ECM
Probable cause
Failed ECM
hope my ECM isnt F*ed
any thoughts?
-
- Moderator
- Posts: 4795
- Joined: Fri Nov 18, 2005 1:41 am
- Location: 313
-
- Expert
- Posts: 342
- Joined: Wed May 07, 2008 4:42 am
- Location: Washington, USA