This engine is ready to come out.
But its not out yet!
Anyone know how many bolts are there for the transaxle to engine. ? (not counting the three torque converter bolts)
Six have been removed.
Can't find any more.
Put a little lift pressure on it (engine) and the front side is lose from the transaxle but the rear (firewall side) seems tight.
Haven't tried much more than that as daylight ran out and I had to stop.
Now I can't sleep waiting for the morning to come

I have the center of the transaxle (it's automatic) supported by a floor jack (with a piece of wood under it) on the left side.
I also have a small bottle jack (with wood) on the right side near the transaxle "brace" where the right axle enters.
I wonder if this support is needed and thinking maybe causing the tightness I mentioned above on the engine/transaxle (firewall) side.
Any thoughts, comments or advice is always appreciated
Thanks