CUSTOM CON RODS & PISTON FOR NUBIRA 2.0!!!

Adam454ss · Post by **Adam454ss** » Fri Aug 26, 2005 12:08 pm

Hey Guys (Ladies too) I emailed this company about a week ago and here is their reply!

----- Original Message -----
From: "Adam Hill" <chevrolet_olrac@hotmail.com>
To: <sales@raceeng.com>
Sent: Saturday, August 13, 2005 8:22 PM
Subject: Con. rods, piston. crank kit ?

> Hello
> I was wondering if you carry a connecting rod/piston/crank kit or parts
> for 2000 daewoo nubira?
> Thank-you for your time.
> Adam

We do not have components on the shelf for the application. We can custom make pistons and rods for the application, but i have no crankshaft available. Custom pistons, Rings and Rod for your engine will cost approx $1,350.00 and take approx 6 weeks to complete.

We may all now bow, kneel and worship!!!!!!!!!!!!!!!

debo890 · Post by **debo890** » Fri Aug 26, 2005 5:06 pm

its about the same price if you made pistons with je for 600 and bout the let rods or custom made it with a company like arrow, etc... good looking tho.

daewooluvr · Post by **daewooluvr** » Fri Aug 26, 2005 5:50 pm

debo890 wrote:its about the same price if you made pistons with je for 600 and bout the let rods or custom made it with a company like arrow, etc... good looking tho.

I was quoted $695 for JE pistons & rings w/o shipping
and $795 for Peuter Rods w/o shipping

Of course I was dreaming when I was looking into this...

Post by **PrecisionBoost** » Sat Aug 27, 2005 9:47 am

Ya..... I was quoted slightly less than $700 for the Pauter rods (because I was enqiring as a company) and the JE pistons were somewhere just over $500 (through a JE distributor that was going to wholesale them to me) ( price did not include rings )

Personally.... I think a combination of JE pistons and Pauter rods would be bulletproof.... I don't think it would be possible to break them.... the block would probably self destruct before they would.

debo890 · Post by **debo890** » Sun Aug 28, 2005 9:17 pm

daewooluvr wrote:
debo890 wrote:its about the same price if you made pistons with je for 600 and bout the let rods or custom made it with a company like arrow, etc... good looking tho.
I was quoted $695 for JE pistons & rings w/o shipping
and $795 for Peuter Rods w/o shipping

Of course I was dreaming when I was looking into this...

same here. thats what i was quoted. they have started making them for me. mine is with shipping tho. all is payed for anyways.