New Chip??? Need Some Input

asam · Post by **asam** » Sat Oct 30, 2004 9:39 pm

What are your thoughts on this. It sounds better than a cheap resistor but still sounds a bit fake.

http://cgi.ebay.com/ws/eBayISAPI.dll?Vi ... 22925&rd=1

Eleven · Post by **Eleven** » Sat Oct 30, 2004 11:34 pm

Two wires? Almost sure its just a resister in there with a switch taht MIGHT be hooked up haha. In anycasem you cant do anything fancy with two wires. If it were anythign active, then it would need (+) and (-) right off the bat. whats that leave? uh.....

not woth it

DomWoo · Post by **DomWoo** » Sun Oct 31, 2004 4:24 am

i agree with you on the chip. its a POS and if you are thinking of buying it send me the money and ill make you one my self

but.... as for you saying you cant do anything with 2 wires?? thats not true, the daewoo ecu is always hot, meaning that all the signals are ran through the ground, when hooking up my greddy piggyback ecu every sensor i hooked up was the ground of a sensor and only requilred 1 wire to be connected, same with the injectors

GutlessSupreme · Post by **GutlessSupreme** » Sun Oct 31, 2004 2:58 pm

Can you say, "Radio Shack"?

xtremelumina92 · Post by **xtremelumina92** » Wed Nov 10, 2004 5:41 am

what are you doing over here gutless?