Need to remove Head off 2001 Lanos. Any Diagrams Available?

lanos · Post by **lanos** » Wed Nov 12, 2008 1:36 am

I finally was able to run a compression check after my timing belt went and found that there is no compression. I heard that there is a specific sequence in which I must remove the bolts otherwise I will warp the head. If anyone knows the sequence or knows where I can find a diagram or step by step instruction on the removal of the head it would be greatly appreciated. Thanks.

Post by **PrecisionBoost** » Wed Nov 12, 2008 1:50 am

Go to Tech Specs in the main forum area.... there you will find two or three links to Lanos info

I think the Lanos specifications at the bottom show the head removal and installation sequence

The bolt torque should be in the torque specs for the lanos.