The original daewootech forum

Well after changing plugs wires valve cover gasket and finally finding a pigtail harness for the camshaft sensor I changed out the sensor, it took me a very long time to find a pigtail harness I'm talking months running around to junkyards posting on any forum I could find, but apparently the camsha...

Does anyone have or know where I can get the wiring harness that clips on the camshaft sensor. When I pulled it off to change the sensor two of the wires were split open and brittle. They are broken very close to the harness clip so using the existing is out of the question. Would like to get the ha...

Aneab I was sending you the pic to the wrong email I think it was an email to the webmaster. Tried the other one so I hope you got them. Please let me know if I sent them to the right email this time and you got the pictures.
Thanks
Jim

Aneab I'd like to take you up on that offer for the wiring harness, put many miles on my daughters car going to junk yards parts stores and googling for the part just about given up. I'd like to pay you something for your time not just the S/H. I have been around for close to 60 years and thought th...

Thank you Aneab you have been a God send for me. Your advice is clear concise and right on. I understand your point about jacking up the engine it would be my luck that the nut would fall into the timing components. So basically I would jack up until the jack and motor were snug and no need to jack ...

A few posts back I mentioned replacing the camshaft position sensor and getting the cover off. In another forum someone said that the engine had to be jacked up before taking the cover off. Someone here thought it probably wasn't necessary and didn't see the need for it. I removed the air filter enc...

Aneab there is where the problem is. The break or the exposed wire is right at the connector. The connector pulled right out with no diffuculty but the 3 wires are so brittle it might have split while removing. Was thinking of getting a new connector and cutting and splicing on to the existing wires...

Picture of valve cover with old gasket attached (hope I did it right). What you describe would be the valve cover kit minus the spark plug gaskets. What I did buy was the valve cover gasket only. There was no grommets for the bolts holding it down. They seem to be in good condition and still attache...

Let me start by saying this is by far the best forum for Daewoos. Very knowledgeable people friendly to boot. As I delve into this little project more questions pop up. If you don't mind putting up with me for a little while longer have a couple of issues/questions. 1) The parts store gave me a choi...

MMamdouh, thank you for the reply-info, appreciate it very much. I have the automatic trans so I guess the sub model is CDX. Guess the hard starting problem is due to the cam sensor. At least I hope so.
Thanks Again.
Jim

I have a 2001 Nubira 4 door. D-Tec 16v owners manual states it is 2.0 DOHC engine. need to replace plugs, wires valve cover gasket, camshaft sensor and oxygen sensor bank 1. There is oil in the spark plug wells so it seems that the valve cover gasket is leaking. Which leads me to these questions/sta...