The original daewootech forum

Hmm....that head might have my name all over it. Ill let you know as soon as I figure out if mine is anygood. (at the shop right now, dead woo in garage)

Two wires? Almost sure its just a resister in there with a switch taht MIGHT be hooked up haha. In anycasem you cant do anything fancy with two wires. If it were anythign active, then it would need (+) and (-) right off the bat. whats that leave? uh.....

not woth it

Whoo Hoo!

http://nlmotoring.com/product_info.php/ ... ts_id/5959

Anyone figure this out, im in the same boat now.

ME!!

Yea, well mine LOOKED fine. Dont make the same mistake I did, or you will be back to sqaure one. As far as I can tell, the head needs to come off to get the intake manifold off

Where to get the euro badges?

Also make sure to remove the valves and everything. I've seen horror stories of people who left the valves in and got back half the valves... If you get 22thou shaved (which is a lot, really) the planer wont touch the valves. They wont hit the pistins, none of that. I JUST did this over the last tw...

Well, I am in no way taking responsibility for you, but I dont think so. If it screws your up, then I am REALLY screwed. I run between 1K and 10K. Just see if you can use an A/F ratio tester, see how rich it is, and if it starts to knock at all, either tone it down with a smaller resistor, or higher...

to shave and pressure check mine was $90. Make sure you take off the Cams, EGR valve ect before you give it to them, or they'll charge to take it all off and back on

22 thousanths shaved will result in a 9.88:1 compression ration. it will also retard your timing 1.8degrees

Daewoo tech.net usees a 1K. Or actually, two 1/4W's in series, but that is irrelevent if you use a 1/2W resistor. (Still over kill)

Dont know why I took so long to ask you all.... A few weeks ago I replaced my head gasket. buttoned it all up, and now it idels around 5000RPM. I can put my hand over the Throttle Body and it still does it. I replaced the Throttle Position Sensor. My header is cracked the wire at my ECU is spliced g...

NyCLatinodeQnz wrote:i almost died, lol.

LMAO. This has t be the most chill dude on the planet. or the biggest fucktard. What exactly happened?

NyCLatinodeQnz wrote:lol.

lol

my only problem with the deawootech.net guages are the cheapness, and the fact that they have thier logo on them. nothing major, but it is just VERY glossy then coated printer paper. qwith some trial and error, you could scan yours and do this yourself