Search found 283 matches
- Mon Jan 07, 2013 4:14 pm
- Forum: Aftermarket and High Performance
- Topic: Lemans/Kadett Project status: ACTIVE
- Replies: 50
- Views: 10298
Re: Lemans/Kadett Project status: ACTIVE
i like the first one myself......
- Thu Jan 03, 2013 12:21 pm
- Forum: Engine/Intake/Exhaust
- Topic: O2 Hack
- Replies: 7
- Views: 1050
Re: O2 Hack
is that a cat a muffler shop keeps on hand? How much is a new cat? those aren't cheap. they are worth a few bucks just for scrap. a few years ago people were cutting them off cars and stealing them to sell.
- Thu Jan 03, 2013 12:19 pm
- Forum: General Off-Topic
- Topic: The longest Thread ever!!!
- Replies: 7136
- Views: 617618
Re: The longest Thread ever!!!
they have to be taken care of or they wouldn't be around! I wonder how many are sitting in junk yards or were crushed because people didn't know about this site?
- Wed Jan 02, 2013 3:41 pm
- Forum: Aftermarket and High Performance
- Topic: Lemans/Kadett Project status: ACTIVE
- Replies: 50
- Views: 10298
Re: Lemans/Kadett Project status: ACTIVE
it looks alot better than when it is on the back of a tow truck!!!
- Wed Jan 02, 2013 3:40 pm
- Forum: Engine/Intake/Exhaust
- Topic: Can anyone suggest reasons rough idle and other strange iss
- Replies: 4
- Views: 587
Re: Can anyone suggest reasons rough idle and other strange
is it throwing any codes? how about your fuel filter? I have had mine run rough like that (no codes) and even shortly after a filter change. I changed it again and it has been fine ever since. it's a cheap and relatively easy thing to fix, especially if you haven't done it before. How many miles? Wh...
- Mon Dec 24, 2012 3:24 pm
- Forum: Electronics/Interior/Audio
- Topic: Speedo working intermittently 00' Leganza
- Replies: 2
- Views: 2121
Re: Speedo working intermittently 00' Leganza
sorry, have a Lanos
- Thu Dec 20, 2012 12:02 pm
- Forum: Engine/Intake/Exhaust
- Topic: Cam timing position sensor replaced, CEL on
- Replies: 17
- Views: 2124
Re: Cam timing position sensor replaced, CEL on
it could be a wire that's bad. I think a few people have had that problem. it could also be that the new sensor is bad too. I don't know how you check that though. when the light is off sometime see if you can get soemone to move the wires a little and see if it throws a code.
- Wed Dec 19, 2012 4:21 pm
- Forum: Engine/Intake/Exhaust
- Topic: Cam timing position sensor replaced, CEL on
- Replies: 17
- Views: 2124
Re: Cam timing position sensor replaced, CEL on
If I remember correctly that camshaft position sensor code clears itself after 3 good ignitition cycles with no codes. if it doesn't get another code it goes out on its own. is there any way that the computer "stores" it until those 3 clean cycles happen, even if you reset it? I had a similar proble...
- Sun Dec 16, 2012 5:48 pm
- Forum: General Off-Topic
- Topic: Has everyone quit this site?
- Replies: 39
- Views: 8240
Re: Has everyone quit this site?
all you have to do is go to the board index page and hit "new posts" and it will list them all for you to review.
- Sun Dec 16, 2012 12:43 pm
- Forum: Transmission/Clutches/Brakes
- Topic: Scary shaking coming from my Nubira
- Replies: 3
- Views: 2164
Re: Scary shaking coming from my Nubira
wow, that is really strange. I can't imagine something mechanical (rotors, bearing, break pads, etc) being intermittent like that. You would think it would be all the time. usually the intermittent stuff would be something witha sensor or electrical. i would certainly check all the lug nuts and stud...
- Sun Dec 16, 2012 12:38 pm
- Forum: Engine/Intake/Exhaust
- Topic: ssssssstutter
- Replies: 6
- Views: 674
Re: ssssssstutter
that is awesome. glad you figured it out!
- Mon Dec 10, 2012 10:09 pm
- Forum: Engine/Intake/Exhaust
- Topic: Lanos 1.6l engine
- Replies: 6
- Views: 1070
Re: Lanos 1.6l engine
i did that with an old van as a last ditch effort andit has been going for over a year. i can' t believe that stuff is any good for the system but it does buy you some time
- Mon Dec 10, 2012 10:02 pm
- Forum: Classifieds
- Topic: SOLD - 2000 Daewoo Custom Fuel Rail w/ AEM Fuel Pressure Reg
- Replies: 9
- Views: 2910
Re: 2000 Daewoo Custom Fuel Rail w/ AEM Fuel Pressure Regula
i thought you fixed your woo and are keeping it on the road for another year?
- Wed Nov 07, 2012 9:26 pm
- Forum: Engine/Intake/Exhaust
- Topic: Springy radiator/heater hose clamps...tool?
- Replies: 5
- Views: 930
Re: Springy radiator/heater hose clamps...tool?
although I like Benzino's response better...... I think this is what you are looking for: http://www.tooltopia.com/lisle-17100.as ... grabber_r1
Yes, they make a tool for those annoying things.
Yes, they make a tool for those annoying things.
- Wed Nov 07, 2012 9:22 pm
- Forum: Electronics/Interior/Audio
- Topic: Headlight plug wiring diagram
- Replies: 8
- Views: 2924
Re: Headlight plug wiring diagram
I've got the wiring manual but I loaned it to a friend and have to get it back. I am going away for a couple weeks, if you can wait? If you figured it out don't worry about it.