The original daewootech forum

oh ok as it has actually turned out im able to obtain a vectra 2.2 easier than finding a t22sed engine code c22sel so i think i may be able to now just use that im just trying to wotk out the cost/benefit ratio at the moment so is it going to be worth the effort going to all the trouble of this for ...

anything further with this?

also

would it be actually worth it to go from a 2.0 to a 2.2 as a baseline? atm i have a 2.0 and im just wondering what to do next
to either go 2.0 n/a (quads cams etc..)
or goto the 2.2 n/a (quads cams etc..)

that is fanastic information! greatly appreciated that difference in rod length is neglible really my only real concern was the big end width, but i guess you can have them surface ground to spec the small ends of the rods arent an issue either as you can ream/machine and fit new sized bushings to s...

oh ok great thanks for that ;) you don't know the big end width of your rods do you? (2.2's?) steel rods that are avail for the 2.2 that i can find have a BE width of 1.039" (26.4mm to be close enough) if the daewoo's journals are smaller than this is there anyreason why you cannot just the big end ...

Ok so what i may be after is a 2.2 non alloy ecotec then? i thought all family 2 variants were belt driven i wasn't aware any of them were chain driven Are you able to please provide pics of the 2.2 crank? also do you have a set of vernier digital callipers? Can you provide the conrod length? hole c...

I'm just trying to figure it out thats all from a bearing catalog here is what is listed so looking at this you would think that the parts would be interchangeable.. THIS IS UNDER THE DAEWOO SECTION OF MAKES/MODELS LEGANZA HAS MOTOR A & C USED THROUHOUT PRODUCTION NUBRIA HAS MOTOR B USED A - Holden ...

Hey guys Im thinking of building up a 2.2 motor however im a bit bewildered as a few members have said that you cannot use the conrods made for the vauxhall 2.2 engine? how is this as you can use the same bearings for either motor? both the daewoo's and vauxhall/holden use the same main and big ends...