The original daewootech forum

Is it possible to mod the back to fit or would it be way too much trouble?

I know someone selling complete leather interior from a 2000 leganza. Will the front and or back seats fit right into my Nubira 2001 SE?

Passenger side fell right out but I had to get a bit rough with the driver side but I got it lol. Thanks fellas!

I finally removed the CV Axle so I can fully access my control arm that I am in the process of replacing... Please explain why in God's name someone would make a "split sleeve" so f*&^ing hard to remove!!! I got the bottom half out but that top half is jammed in there damn good. Any tips on removing...

So no one here knows how I can remove my axle from the transmission? Is there any special clamp or pin i need to remove? SHould my tranny be in P, N, D, R, or anything else?

I am replacing my driver side lower control arm. I have to remove the CV Axle from the transmission so I can get to a long bolt. I can not for the life of me pull the axle from the transmission! I have plenty of wiggle room...i took the hub assembly off of the strut so I just have connected tie rods...

My AC cooler does not work, it just blows in luke warm air... I bought a recharge kit and located the pressure valve...the only one that would fit to the 134a or whatever # on the can, which matched what my manual said. The guage displays full pressure without me putting any of the refrigerant in. I...

http://www.daewoous.com/Catalog.aspx?mo ... group=5310

This is for an 01 nubira...

I am not looking for anything in particular, I work for the second largest food broker in north americal and was just wondering if anyone else was in the industry...

Anyone here work in the Consumer Packaged Goods industry? Food retailers, manufacturers, wholesalers, food brokers, retail sales/marketing...?

Yes, and the other bolt on the tranny is supposedly the plug that determines if there is enough tranny fluid in it. I have yet to attempt to check my tranny fluid because you have to evenly hoist the car up, undo both the plug and the overflow bolt and fill it until ATF starts to pour out of the bot...

They make liquid polyurethane...if I were to completely fill both sides of the mount and let it dry then if it is too firm I can drill 4 or so holes through it to make it have more give...

I came across some info about rubber cements while researching ways to secure and snug my rattling interior (it is not that bad I just got bored...) and got to thinking about my front mount...if the bushing is ripped and wore out, then rubber cement can most definitely repair and even make the mount...

THanks, you guys are f****** awesome! I will take off my front mount tomorrow or tonight, if none of my boys wanna go have a beer. THe front mount does not look to be that difficult to remove. ANy tips to remove the front mount? Maybe a GUide? I am going to search now, otherwise feel free to leave m...

o_o ?????