The original daewootech forum

does anyone know the part# of the walbro pump that works with our fuel pump assembly on the lanos 1.6? also i've encountered a problem with my walbro 255 and 10:1 fmu, with 2.0 map sensor..car runs good for about the first 10-20min but after that the car misfires and seems like its runny out of gas....

hi im wondering if anyone has been able to install a walbro in the new fuel pump assembly design? the daewoo original design is not being made and the ones from junkyards are not in good condition, the original pump assembly on the top portion of the canister has a thick rubber o-ring sealed with a ...

so are the 370ml inj enough or need higher? and which ones can i get that are compatible? thanks

im trying to get the smt7 and i will be installing it hopefully soon, any suggestions on what i will need with this setup? thanks

hi in need of smt7 for lanos 1.6l dohc turbo project

if i go with the smt7 and up to 7psi do i need get bigger injectors(currently have 2.0 nubira inj.)? if so where can i get a hold of and what size 370mL? thanks

i'm stuck with a decision to make; i could try to make it work with what i have now and spend about 2 hrs on the dyno and the car running ok or get either smt6 or smt7 install dyno it and have the car running good? what should i do?

what engine are the pistons for?

right now i have the 2.0 nubira injectors, no fmu(its disconected, its a vortech), the missing link valve, stock map sensor, walbro 255, and the safc2. My goal is to up to 7psi, in that case what would you recommend given the info you posted before, what would i need to get my car ready for tuning o...

any suggestions? bump

i had the 2bar map sensor and had to take it out, car was runing very rough, what about the voltage signal to the ecu from the map sensor aren't different from the 1bar to 2 bar, wont that trigger check codes? i have with current setup walbro 255, and 2.0 nubira injectors, would replacing the inject...

bought th synapse valve installed it, just waiting to take woo to dyno for tuning, which piggy backs have you guys used or recommend, i saw the smt6 is quite good with fuel and timing? any suggestions

i found one on ebay, just wondering are they universal or do we need a part# is this a decent valve from nippon?

http://cgi.ebay.com/ebaymotors/D15-D16- ... enameZWDVW

thanks so im looking to buy one on ebay, (ml check valve) so for now wait to dyno an take it from there?, so keep the fmu out for now? i also have the msd dis-2 and the driver efrain built for it, should i install that now or after dyno? thanks

i have 6 check valves and for some reason it still reads it, i will check the missing link sensor will this help keep the map sensor from reading +pressure? also any of you guys have safc2 with your setup? any suggestion on the check valves are you guys using any specific? any help or advice appreci...