The original daewootech forum

if you have abs fitted check the abs gear ring, i hade a similar sound from the front of my legenza, almost was about to pull the differental apart but discovered a split in the abs ring. removed the ring the click went with it. although i now need a driveshaft as the don't sell just the ring

leganza 2001: hi have a problem with abs, its very simple ;) the geared ring on the front driveshaft has broken off, so now the abs light stays on. question can one buy this ring or do i have to buy a full driveshaft? (it would be a pity to scrap a fully servicable drive shaft). i am aware that the ...

back of the engin below the intake manifold and above the righthand side drive shaft ..
yea nice and easy to get at (sarcasim)

whats wrong with yours

no idea how it works

try taking the valve cover off turn the engin by hand and see if oil comes up into the cams,sounds like the oil is not getting to the cams the gallery's could be blocked, try draining the oil then, flushing the system, new oil filter, fresh oil.

well! stripped out the clutch the problem fell into my lap, one of the springs have come out of the clutch plate, new clutch kit problem cured, can get all gears soooo smooth.. have to find new way to exercise my left thigh muscle
thanks to those that answered

i drive a leggy and if the leak is that far up it is usually the rubber gasket in the valve cover.cheap fix.just make sure the new one is seated correctilly before tighting

thanks m.. the fluid was changed when the master and slave cyclinders were changed.(dot 5.1); ithink the only answer it to strip the clutch out, i am suspecting either the relise bearing sticking on the shaft or a bent finger on the clutch plate, either way it has to come out.... i was prob being la...

changed both master cyclinder and slave cyclinder but very little change.the car can be driven as long as the gears are "nursed into" gear the solid peddle is still there randomally but it only seem to be on down shifting but i have noticed that if you "blip" the throttle when the clutch peddle feel...

hi guys/gals, the clutch on the leggy has become random,or at least the pedle operation has. at times the clutch pedle feels like theres a brick under it but after two or three tries it reverts back to normal,other times the clutch operates perfectly then out of the blue the gears are difficult to s...

when i first did my leggy i was also bemused by this. firstly if you removed the rocker cover set it back in place, as you look at it from the cam gear end the left hand mark on the cover refers to the inlet so use the line on the cam gear that has inlet stamped beside it (on the inner rim i think),...

replaced all spining parts(waterpump,idlers, tensioner) plus oilseals,and while i was at it checked the ohc bearings. upon close inspection found that on the inlet cam the bearing closest to the timing belt had a slight burr to one edge, so i rubbed it of with very fine wet and dry being careful not...

yes checked that,as i said i removed the belt and the noise continuied, besides the tensioner
spins freely with no roughnes or side movement

thanks any way

has anyone any ideas about what could be causing this. engin screams intermittily,like a banshee!! sounds like its from the front of the camshafts (poss the inlet), removed the fan/ alternator belt the scream is still there,did this to discount bearings in alternator, ac pump, powersteering, the ten...

thanks M. just finished replacing it , started a 4pm it now 11.30 what a pain in the ass. parts list say these are 34mm but also mentions a 36mm so she who must be obeyed was dispatched this morning to purchace said items.she got both (smart) cost 20p (thats about 12cents american) each. After remov...