The original daewootech forum

well it's an easy task to wire this just cut the wire to the starter relay and pick up power from the on slot, so you will need the key to start it (make it so no one can jump in and steal your car) but to actualy start it you have to push the button, or tap the starter wire so you can still start i...

problay a 1.4Kw if it's a auto 1.2Kw for the manual, more power for the auto.

and to add the point thats what causes your cut off, with basical causes the beam patter to be pointed down, it's all in a parabolic reflector (you though learning that stuff in school was crap) and the high beam is just hitting it at a diffrent angle. you can take it out only if you had fluked head...

post up how you wire up that tach, like if the wires and harnest is already there that would be sweet, if you have to run some in make sure you write down how you did it.

1. shot in the dark there maybe about 30 or so? (cr does good gains) 2. you need to make sure they are the same bore and deck hight info, they maybe 10.5 in the c20xe but they can actualy be lower or insainly higher when used in yours (i'm not an expert with daewoo engine someone else can fill this ...

ebay.co.uk

usdm didnt have the tacho you need to go over seas laddy

i was just wondering if the a/c belt snaping is a common issue on the lanos engine? my friend 1st got his car and i took it to the red line and the belt snaped, and his bro just got another lanos (wrecked his 1st one) and the belt was snaped about a week after. just wondering if this is a common pro...

why not use an eaton setup off a toyota mr2. Ive seen them used on FJ20's and Sr20s, 20valves and all sorts of different motors. That would be the most logical way to do it in my mind @ Woo: Well the reason I proposed this Vortec type setup is because of the greatest simplicity and economy, it woul...

strip off the insulation and then mesh the 2 wires togeather and then heat the wires with it iron, then put the solder on it. then coat with tape

hot means it has power going though it (postive line)

cold means it's a ground line (negative line)

yes they are idiots most of the time >.>

http://sparkplugs.com/results_app.asp?p ... IA=1371833

or you can say you have a 96 toyota paseo and get the dual ground copper plugs /drool

black is ground red is power, or if it's black and white then white is power, or if it's black and blue then blue is power ...... get where i'm going? you can sand paper any metal point on your can and screw the wire there and get ground. you can also get a volt meter and use that to test what wires...

his cia is dryer hose i should know i had a dryer hose cai for a little bit till it distroyed it self some how. now to be mean gtr badge sucks they sell goo off to take off that tape stuff. jdm wires? that kit isnt at all jdm. infact it wount matter where it's made. it's a grounding kit. ebay chip? ...

http://www.daewootech.com/forum/viewtop ... ight=relay

someday i'll make a real how to wire everything up with a relay thread.

look for my old post where i told people how to wire up a relay. your going to want a relay on those probaly can just buy a predone relay kit made for fog lights and just wire that in since i probly comes with a switch, just pick up power from that kit.