The original daewootech forum

you need a modded crank for a lower stroke, shorter rods, higher comp pistions, diffrent cams, dual valve springs, way over bored block, and your engine will idle like crap or at around 2k. also rotory engine? they rev to 10k but you need to take it that high to get anywhere.3 also there was a toyot...

lack of egr wount matter at WOT it shuts off and no exhaust gets in. you wount want to use the leaded ecu because it would use a diffrent timing map. but the advantage is you turn a screw and you can increase or lower your a/f but that can be still achived by a piggy back like the smt or an adjustab...

also when you put the resitor in put it on the postive line.

OOOOOOOOOOOOOOR, if you get a ecu pin out you can find where the speedo wires differ, and for the auto tranny missing on the manual, you can trick the ecu buy putting a LARGE resistor that will throw the wires for the solinods to ground.

your high reving too might be cause by it burning off extra cleaner.

WOOOOOOOOOO! i was right! but what wires did you have on your car? i had the cheap ones from autozone break apart when i went to take them out from the car.

check wire resistance, then coil, i forgot how the coil system works, one coil runs 1 and 3 or was it 1 and 2? also make sure for a good ground connection.

i changed my mounts with aftermarket ones and distroyed them in 2 years, the stock ones were on for about 6 years.

Pimp!

your engine sucks in WAY more air than 400cfm to get notice able boost. 1 cubic feet = 28.3168466 liters ok so for the nubria (easy to work with numbers) you have a 2l engine. so 2 liters = 0.0706293334 cubic feet now at WOT 0.07CF x 6000RPM = 420 CFM Shouldn't you count only two cillinders at a ti...

well have you checked your wires? clean all the ground points, grounding kits, i need to clean out my grounding points on my car right now, also what type of wires do you have, rember bigger doesnt mean better, the car has to be able to produce a large enough spark to travel too it. the pontiac guys...

polyurethane comes in diffrent types than windshild glue, i have some right now that used to fill cracks in driveways and stuff. i seen it on drive ways and this stuff is hard, it's the gray stuff you see sometimes filling cracks.

i tried it before, it is messy, it gets everywhere and hell to clean. also make sure you let it cure for at least 24 hours, i'll say 48 if you can. i was impatiant and ya.

the nubi 2.0 flywheel is ligher and smaller and perfect fit i belive. search around here i forgot who did it.

oh here a quick link i found

http://www.daewootech.com/forum/viewtopic.php?t=6110