I bought this scanner http://www.amazon.com/Crescent-OBD2-Mul ... 158&sr=1-1 to use in my RHD 2001 2.0L Leganza CDX but it wont connect to the vehicle. Can anyone confirm if this vehicle is OBDII compliant?
Thanks.
2001 Leganza OBD support
Moderators: daewoomofo, Moderators Group
Re: 2001 Leganza OBD support
If it is OBD II compliant you must find a label "OBD II certified" somewhere.
Ex:
Ex:
-
earlybirddisco
- Posts: 2
- Joined: Fri Jul 02, 2010 11:55 pm
Re: 2001 Leganza OBD support
The Vehicle was imported from Korea for the Caribbean. Its a Right Hand Drive and has no such label which I suspect is only atached to vehicles for sale in the USA. The engine is a C20SED another site says it should be OBDII and the scanner says it supports the protocol but I am unable to connect. I have tested the scanner on another vehicle (not daewoo ) and it works. I unmounted the obd connector and all wire seem to be ok. If I was to get the numbers off the ecu box would that help?
Thanks.
Thanks.
Re: 2001 Leganza OBD support
Maybe someone (not me) on this board could answer with the help of ECU number.
Take the following with reserves since it's only my intuition: OBD II management have two oxygen sensors, one pre-cat and one post-cat. How many O² sensors do you have.
Also take note that some Daewoo's (around 2000-2001) have a OBD II shaped connector but with ALDL protocol like on my Nubira
Take the following with reserves since it's only my intuition: OBD II management have two oxygen sensors, one pre-cat and one post-cat. How many O² sensors do you have.
Also take note that some Daewoo's (around 2000-2001) have a OBD II shaped connector but with ALDL protocol like on my Nubira