16 V 1600 Turbo

wolfhound · Post by **wolfhound** » Thu Jun 29, 2006 6:29 pm

Hey guys check out old pics of my Woo on www.200-plus.com under Sean.

They were taken a year or so ago. Seats have been recovered a dark charcoal instead of the "show up any stain" Daewoo light grey with "really terrible floral print"

Have since sold those big ass 10" Audiopipe subs and amps, to be replaced with my new Audison amp and Hertz subs. and the whole sub install is getting airbrushed.

Sean

Post by **PrecisionBoost** » Tue Jul 04, 2006 3:33 am

Too bad you didn't have pictures of the engine.... you listed a turbo.... what kind of setup do you have ( engine mods, boost levels )

wolfhound · Post by **wolfhound** » Tue Jul 04, 2006 5:57 am

Chris, I'm the same guy with the broken pistons,

Will get some more shots of the motor when its all back together ...... this Saturday ....hopefully.

Séan

sim0ng · Post by **sim0ng** » Mon Jul 17, 2006 2:21 pm

nice install but you need to tidy up those wires to the subs going out behind the seats

wolfhound · Post by **wolfhound** » Tue Jul 18, 2006 5:54 am

Subs were only in on a temporary basis. I ran my own sound fitment centre at the time. so it didn't make sence to drill holes in the fibreglass until i had decided what I was gonna do as far as amps and subs were concerned. THAT is the reason the wires are sitting loose, they ran behind the seat to a 1250rms Audiopipe Mono Block amplifier.

And if you read the story, I stated that all the sound that is in the picture has since been sold.

Whole install is to be airbrushed and finished as soon as I ge the Turbo running properly.

Séan