Just wondering that although on these engines the eccentric water pump isnt used to tension the belt as it was on the old SOHC engines...some WPs still have the 41mm hex on the body to turn them..but in what position should it be positioned, b4 the bolts are tightened, and then the adjuster pulley set?
and what is the purpose of the pointer tab on the hub?
Water Pump position, DOHC Leganza
Moderators: daewoomofo, Moderators Group
Re: Water Pump position, DOHC Leganza
There was a topic somewhere on this board concerning your question.
If I remember well when it's not possible to get the correct t-belt tension by adjusting the auto-tensioner, you have to play with wp position.
If I remember well when it's not possible to get the correct t-belt tension by adjusting the auto-tensioner, you have to play with wp position.
-
- Posts: 47
- Joined: Sun Jan 08, 2012 3:24 am
Re: Water Pump position, DOHC Leganza
oh, ok...maybe Ill just note the old WP angle before I undo it, and hope the new WP is same relative layout as the old one, even though probably different brand.
the trouble I had getting info on replacing the water outlet stub in block behind WP..
the trouble I had getting info on replacing the water outlet stub in block behind WP..
Re: Water Pump position, DOHC Leganza
I've read that. I would follow benzino's solution in his post http://www.daewootech.com/forum/viewtop ... 92#p122364 . Maybe doing that on the motor out of car.MatesLeganza wrote:oh, ok...maybe Ill just note the old WP angle before I undo it, and hope the new WP is same relative layout as the old one, even though probably different brand.
the trouble I had getting info on replacing the water outlet stub in block behind WP..