2000 Leganza cdx ecu pinout needed

[jl93sundance]

Does anyone have an ecu pinout diagram for my leganza?, more specifically the cam position sensor location. Any help would be appreciated!, thanks.

[benzino]

if you look at the top of the engine, cam sensor is to the far left hand side in the centre and can be seen going in to the spark plug valley... there are two sets of wires that run over the top of the engine, just follow the one that stops on top of the engine and you will find the cam sensor

[jl93sundance]

Yes I know that, but I need the pin out of the ecu.

[benzino]

then it's a Brown/white wire going to D11 (which is on the white plug)

[jl93sundance]

Ok thanks..one last question, where is the pin out of the voltage supply line to the cam
sensor?

[jl93sundance]

Actually I should say where should I track down the voltage supply line to the sensor as I am not getting any power to the sensor.

[Daniel]

Actually I should say where should I track down the voltage supply line to the sensor as I am not getting any power to the sensor.

You should find power and ground to the cam sensor at C103 (pin D3 ground and pin F9 12v) under the engine fuse box.

leganza.JPG

[jl93sundance]

There's an inline fuse underneath the fuse box, is it suppose to be a 15 amp fuse is what I'm seeing from the diagram?.. there was a 5amp fuse that was blown there.

[Daniel]

F13 15Amp is normally located in habitacle. Did you find it in engine bay?

There was a recall for Nubira about melted camshaft sensor. Check current drain from yours but 5Amp seems low.

2000 Daewoo Nubira Recall Details
1. NHTSA Campaign ID Number: 04V394000

Recall Date:2004-08-06

Summary:ON CERTAIN PASSENGER VEHICLES, THE CAMSHAFT POSITION SENSOR MAY MELT RESULTING IN A BURNING SMELL AND VISIBLE SMOKE, WHICH MAY SUBSEQUENTLY LEAD TO THE MELTING OF THE CAMSHAFT COVER AND THE CAMSHAFT POSITION SENSOR WIRE HARNESS.

Consequences:THIS COULD POSSIBLY CAUSE AN UNDERHOOD FIRE.

Remedy:DEALERS WILL REPLACE THE CAMSHAFT POSITION SENSORS AND INSTALL AN ADDITIONAL FUSE.

OWNERS SHOULD CONTACT DAEWOO PUERTO RICO AT 1-877-362-1234 OPTION 6.

Component Affected:ENGINE AND ENGINE COOLING
Potential Cars Affected:4,305
Notes:DAEWOO MOTOR DE PUERTO RICO

[jl93sundance]

Yes, it seems that the recall was performed on my car, the fuse is located underneath the fuse box in line with the voltage supply line before it reached the fuse box. I wonder if I should switch back to a 5amp. Thanks for the help, i'm glad I got this issue solved.

[Daniel]

F13 15A protect also ECM, Ignition relay1, vehicle speed sensor, fuel pump relay.

On this Bosch site http://apps.bosch.com.au/motorsport/pro ... efault.htm you can find that a Hall effect sensor drains very little current. About 0.010A.
So probably the 5A fitted fuse was just fine.