Search found 527 matches

by Spider
Sat Sep 20, 2008 11:56 pm
Forum: Engine/Intake/Exhaust
Topic: What should the pressure be?
Replies: 15
Views: 1216

............... I found a pump on ebay for 147, that's the cheapest place i've found, you know of anywhere else? These people are good, I've bought from them.. They just sold a Lanos oil pump for $57.00 (usd) How much more could a pump for your engine be? Try a search at their store: http://stores....
by Spider
Sat Sep 20, 2008 5:19 am
Forum: Engine/Intake/Exhaust
Topic: What should the pressure be?
Replies: 15
Views: 1216

Posted twice..deleted this one.
by Spider
Sat Sep 20, 2008 5:14 am
Forum: Engine/Intake/Exhaust
Topic: What should the pressure be?
Replies: 15
Views: 1216

Ok than Josh, It's not loose crank bearings if it were, you would hear heavy "thud' (knocking) from the bottom-end which would speed up accordingly as you brought up RPM's. These a strong engines, especially the bottom-end. So, it must be the oil pump. What else could it be? You have eliminated ever...
by Spider
Thu Sep 18, 2008 8:17 am
Forum: Engine/Intake/Exhaust
Topic: What should the pressure be?
Replies: 15
Views: 1216

Very good post, i'll try to answer everything. I figure my gauge is good now that it is the second time i've seen pressure drop. When i say drop i mean it goes to 0. I don't see how my little test couldn't be accurate because even if my gauge was bad and 0 actually meant i had about 7 or 8 pounds, ...
by Spider
Sun Sep 14, 2008 7:19 am
Forum: Engine/Intake/Exhaust
Topic: What should the pressure be?
Replies: 15
Views: 1216

I think i do have a pressure problem. I drove the car for a while this evening. It starts off fine, with good pressure but after it really gets on the road and warmed up the pressure gets weaker and weaker. I thought i had a bag gauge, but i did a little check and while the car was idiling i loosen...
by Spider
Thu Sep 11, 2008 6:21 am
Forum: Engine/Intake/Exhaust
Topic: What should the pressure be?
Replies: 15
Views: 1216

Re: What should the pressure be?

Well i finally got the Nubria put together and started. My oil pressure light is still coming on, so i bought a gauge. I pulled the sensor out (1wire) and put the gauge in it's place. I was a bit suprised that the light didn't come on since it was unplugged. Cold the engine ran about 52 lbs of oil ...
by Spider
Wed Sep 03, 2008 4:23 am
Forum: General Off-Topic
Topic: Hey guys, How's it a going?
Replies: 7
Views: 889

Hey lanowoo,
Didn't know you were gone as I haven't hardly been on here myself this summer. Welcome back !
Question: Is a N.S "gallon" the same size as a U.S. gallon? I am lucky if I can squeek 30mpg out of my woo. Got 130k miles on mine and it's runnin good too.
by Spider
Wed Sep 03, 2008 12:34 am
Forum: General Off-Topic
Topic: The longest Thread ever!!!
Replies: 7136
Views: 537476

Hey guys! Im baaaaaak ! I missed this forum...been in a "slant 6" forum all this summer, cuz I'm working on and working on an old 1963 Dodge D200 pick-up. getting it road worthy.. I got it for next to nothin from my son-in law it had no powere and would only go about 40mph but i got all that sorted ...
by Spider
Tue Sep 02, 2008 11:43 pm
Forum: Engine/Intake/Exhaust
Topic: Ticking/knocking noise - Timing belt?
Replies: 10
Views: 1356

Re: Ticking/knocking noise - Timing belt?

Hi all, Long time lurker, first time poster, love my daewoo lanos! Anyway, i've noticed in the last few hundred miles that i've been driving the car, its started to develop abit of a knocking noise. It sounds more like *duck duck duck duck*. It only happens when the car is really cold and at low rp...
by Spider
Sat Jul 19, 2008 11:57 pm
Forum: Engine/Intake/Exhaust
Topic: A/C work
Replies: 12
Views: 873

the belt tonsioner is easly accesable from underneith. if its squealing its the belt. get a new one and ill bet all of your problems will go away i have change my belt very easy to do a big "PLUS 1" to the above. As i recall, you need to remove a couple of those under fender plastic splash-shields ...
by Spider
Fri Jun 27, 2008 9:38 pm
Forum: Engine/Intake/Exhaust
Topic: Emergency! Need Lanos CPS Help!
Replies: 10
Views: 736

Re: Emergency! Need Lanos CPS Help!

Hey guys, I'm on vacation, and I think my Lanos CPS (Camshaft Position Sensor) has taken a dump. I drove the car for about 160 miles down to Captiva Island. About 30 miles shy of the destination, the car started to run funny. The power in gear was low, and I could not accelerate well. The car ran, ...
by Spider
Fri Jun 27, 2008 9:04 pm
Forum: Engine/Intake/Exhaust
Topic: Emergency! Need Lanos CPS Help!
Replies: 10
Views: 736

a quick reply

Here is a Daewoo tech. knows his stuff.

PHONE: (877) 463-2396 (option 6)~ ( "JOHN"~Tech) starts at 6:30 am. works Monday thru Friday

He is in Compton Ca. so, 3 hours behind your time.

I will send some other ideas soon.
:)
by Spider
Tue Jun 17, 2008 11:37 pm
Forum: Engine/Intake/Exhaust
Topic: A/C Problem 2001 Lanos
Replies: 14
Views: 945

ok do this. start the car, and turn the air on. does the blower motor turn on? now (while the car is running) pop the hood. you should see he center section of your a/c compressor turning with the outer part of it. if you dont you might have a leak in the a/c system. if it is spinning then im stump...
by Spider
Tue Jun 10, 2008 8:01 pm
Forum: Engine/Intake/Exhaust
Topic: Oil pressure light
Replies: 36
Views: 3006

Gah-dam! I hope I didnt fu*k my car. So, in the case that it possibly maybe a crank or rod bearing is this a fairly simple fix, like an average joe could do it, or is it beyond me? (Please do not take into acct my stupidity for running car like I did :lol: ) Or I suppose if I have to ask, maybe I s...
by Spider
Tue Jun 10, 2008 7:25 pm
Forum: Engine/Intake/Exhaust
Topic: Oil pressure light
Replies: 36
Views: 3006

Re: Maybe

No, the turbo is not on the car. Everything has been reverted back to stock. Sensor in stock location. No oil ines hooked up. It was a T3/4 turbo. Drove car home last night, no light. I even raced another Aveo and took it up over 100, it was risky but worth it. Drove car to work this morning, no li...